Installation Instructions

User Manual: WaveLinx Lite (1.5)
48
www.cooperlighting.com
The scene defaults for Scenes 1 through Scene 6 can be modified to respond in a different manner. The OFF scene cannot be modified.
Internet connection is not needed to modify scenes but connection to the WaveLinx Lite device/network is required. The mobile device will
need to be in range and as close as possible (within 60 feet) to one of the WaveLinx Lite devices that belongs to the same area
To modify scene levels:
1: Bring the mobile device within range (within 60 feet) of any provisioned WaveLinx Lite device in the desired area.
2: Ensure that the mobile device Bluetooth is turned on, and then open the WaveLinx Lite Mobile Application.
3: In the site list, select a site.
4: In the area list, select the desired area and verify that the network is connected.
5: Tap ‘Scenes’ to open the scene list.
6: Tap the gear icon ‘ ’ on the row for the desired scene.
Note: Tapping the row of the scene anywhere other than on the gear icon will issue the scene command and change the light levels.
7: Set the scene attribute options first. This includes:
• Optionally changing the name. Tap the name field and type the
desired unique scene name.
• Slide the switch to select between the option to adjust in ‘Static’
mode or ‘Live’ mode. Adjustments to the scene levels made in
‘Static’ mode will have no effect on current light levels.
Adjustments made in ‘Live’ mode happen in real-time to allow
visibility of the effect on lighting.
Note: If adjustments are made in ‘static’ mode and then mode is switched to
‘live’, lighting may not reflect the adjusted levels. Adjust to another level and
then back to the desired level to refresh light levels.
8
: Assign the desired zone operation for each zone in the scene.
• Optionally uncheck a zone to ignore it from the scene. The
ignored zone will stay at its previous light level when this scene
command is issued. If zones should operate as part of the
scene, make sure they are checked.
• Use the adjustment tools in each zone section to modify the
scene response, adjusting the percentage for each zone. Scroll
down to see additional zones beyond the page view.
9
: Tap ‘Save’ to save the changes and then repeat for any additional
scenes that require changes.
Scroll to view and
update additional
zones in the area
Optionally change
the scene name
Switch between ‘static
and ‘live’ mode
• Check to include
zone in scene
• Uncheck to ignore
zone in scene
Use adjustment tools
to change each zone to
the desired light level
Tap ‘save’
Select the area
Tap ‘Scene’
Tap the gear icon for
the desired scene
Select the site
Verify network
connection
Connected
Not connected