Installation Instructions

User Manual: WaveLinx Lite (1.5)
www.cooperlighting.com
25
6: Tap the desired occupancy set.
7: Tap the ‘Zones’ option.
8: Review the assigned and available zones. To add zones, tap ‘ ’ next to the zone. To unassign a zone, tap ‘ ’ next to the zone.
9: Repeat until all zones are assigned to the correct occupancy set. When complete, the ‘Available Zones’ section should be empty unless the
remaining zones will not respond to occupancy commands.
Step 6: Provision Remaining Area Devices and Assign to Zones
Once the zones and occupancy sets are defined and assigned, provision the remaining devices in the area.
Internet connection is not necessary but connection to the WaveLinx Lite device/network is required. The mobile device will need to be in range
and as close as possible (within 60 feet) to the WaveLinx Lite device being provisioned.
To provision the remaining devices:
1: Select the next WaveLinx Lite device to be provisioned. With the mobile device, stand as close as possible to the chosen WaveLinx Lite
device (within 60 feet).
2: Verify that the device is displaying the correct out-of-the box and LED behavior for an unprovisioned device as described on the device’s
reference sheet in the “WaveLinx Lite Device Reference Sheets” section beginning on page 6.
3: Ensure that the mobile device Bluetooth is turned on, and then open the WaveLinx Lite Mobile Application.
4: In the site list, select a site.
5: In the area list, select the area where this device should be provisioned.
6: In the area details, scroll down to the ‘Unassigned Devices’ list, and then tap the refresh icon ‘ ’ to start a device scan.
Select the
occupancy set
Select ‘Zones’
Tap ‘-‘ to unassign
Tap ‘+‘ to unassign
No more available
zones