Owner manual

Series 7 Digital Force Gauges User’s Guide
32
14. Any errors are reported by the following screens:
Displayed at the start of calibration if a disallowed unit is selected.
Ensure that the load is not swinging, oscillating, or vibrating in any manner. Then try again.
The calibration weight does not match the set value.
The entered calibration point is too close to the previous point.
CALIBRATION
TENSION
Load too close
to previous.
Please try again.
CALIBRATION
Load not stable.
Please try again.
CALIBRATION
Units must be gF.
Please try again
Press ENTER.
CALIBRATION
COMPRESSION
Load too low.
Please try again.