Manual

2.6 Specifications
These specifications are subject to change without notice.
Enclosure Rating: NEMA 2 (standard),
NEMA 4 (optional; not available with AC Adapter
power)
Diameter: 3.7 inches
Linearity and Hysteresis: .2% of full-scale, linearity and hysteresis (better than
test gauge accuracy)
Operating Temperature: 30 to 160 °F (standard),
0 to 180 °F (with NEMA 4 option)
Pressure Ranges 0 to: 1, 5, 15, 30, 50, 100' 200, 300, 500, 750, 1K, 1.5K,
2K, 3K, 5K, 7.5K, 10K PSI
Calibration Engineering Units: PSI
Built-in Engineering Unit
Conversion:
PSI, bar, mbar, inH
2
O, inHg, kPa, mmHG, MPa,
ftH
2
O (field selectable)
Special Engineering Units: Optional
Display: 4 ½” LCD digits, 0.5 inches high
A-to-D converter sample rate: 7.8 kHz
Frequency Response ( -3dB): .78Hz
Display, Limits and Output
Update Rate:
3 per second
Pressure Port: below 500 PSI:
1/4-18 NPT male
500 PSI and above:
9/16 -18 UNF-2B female with SAE spec J514 O-ring
boss
Power Requirements: Battery Powered:
one or two 9 Volt alkaline batteries
AC Adapter Powered:
110 VAC@60 Hz adapter (included)
Vehicle (DC) Powered:
11 to 32 VDC (3 ft. cable included)
Wetted Parts: Stainless steel
Housing Material: Stainless steel
High and Low Capture: Standard, same update rate as display
Zero and Span Adjustment: Standard
Front Panel Membrane: Tactile feedback, raised buttons
Calibration Data: Stored on non-volatile memory chip
2.7 Accessories
< 500 PSI
instruments
>= 500 PSI
instruments
PRESSURE ADAPTERS (Zinc Plated Steel)
To 1/4 -18 NPT female
√ √
To 1/4- 18 NPT male N/A
√
To 7/16- 20 UNF male with 37 degree flare
√ √
PRESSURE ADAPTERS (Stainless Steel)
To 1/4 -18 NPT female
√ √
To 1/4- 18 NPT male N/A
√
To 7/16- 20 UNF male with 37 degree flare
√ √
PANEL MOUNTING RING
√ √
CARRYING CASE
√ √
DPG 100 5 Rev Feb 2001