Owner manual

DFI INFINITY CS (V- M3598/N/0906) 2 CF 70

NOTE: provides you with information that is important to successfully setup and use the Programmable

Digital Meter.

CAUTION or WARNING: tells you about the risk of electric shock.

CAUTION, WARNING or IMPORTANT: tells you of circumstances or practices that can affect the meter’s

functionality and must refer to accompanying documents.

TIP: provides you helpful hints.

1.0 INTRODUCTION

1.1 Unpacking

Remove the Packing List and verify that all equipment has been received. If there are any questions about the

shipment, please call Cooper Instruments at 1-800-344-3921.

Upon receipt of shipment, inspect the container and equipment for any signs of damage. Take particular note of

any evidence of rough handling in transit. Immediately report any damage to the shipping agent.

The carrier will not honor any claims unless all shipping material is saved for their examination. After

examining and removing contents, save packing material and carton in the event reshipment is necessary.

Verify that you receive the following items in the shipping box:

QTY DESCRIPTION

Programmable Digital Meter indicator/controller with all applicable connectors attached.

Owner’s Manual

Set Mounting brackets

If you ordered any of the available options, they will be shipped in a separate container to avoid any damage

to your indicator/controller.

1.2 Safety Considerations

This device is marked with the international caution symbol. It is important to read this manual before

installing or commissioning this device as it contains important information relating to Safety and EMC

(Electromagnetic Compatibility).

This instrument is a panel mount device protected in accordance with EN 61010-1:2001, electrical safety

requirements for electrical equipment for measurement, control and laboratory. Installation of this instrument should

be done by qualified personnel. In order to ensure safe operation, the following instructions should be followed.

This instrument has no power-on switch. An external switch or circuit breaker shall be included in the

building installation as a disconnecting device. It shall be marked to indicate this function, and it shall be in close

proximity to the equipment within easy reach of the operator. The switch or circuit-breaker shall not interrupt the

Protective Conductor (Earth wire), and it shall meet relevant requirements of IEC 947-1 and IEC 947-3

(International Electrotechnical Commission). The switch shall not be incorporated in the main supply cord.

Furthermore, to provide protection against excessive energy being drawn from the main supply in case of a

fault in the equipment, an overcurrent protection device shall be installed.

• Do not exceed voltage rating on the label located on the top of the instrument housing.

• Always disconnect power before changing signal and power connections.

• Do not use this instrument on a work bench without its case for safety reasons.

• Do not operate this instrument in flammable or explosive atmospheres.

• Do not expose this instrument to rain or moisture.

• Unit mounting should allow for adequate ventilation to ensure instrument does not exceed operating

temperature rating.