Owner manual

DFI INFINITY CS (V- M3598/N/0906) 24 CF 70
• = Medium Brightness
•
= Low Brightness
•
= High Brightness(Default)
3. Press the S/NT/GRS button to toggle between available choices.
4. Press the MENU button to store your selection. The meter momentarily shows
followed by ,
, , and then measured value.
5.0 DISPLAY MESSAGES
Table 5-1 Display Messages
MESSAGE DESCRIPTION
Strain Meter
Hard (Power On) Reset
Input Type
Decimal Point Position
Reading Scale and Offset
Reading Configuration
Display Color
Setpoint 1 Configuration
Setpoint 2 Configuration
Setpoint 1 Deadband
Setpoint 2 Deadband
Output configuration
Output Scale and Offset
Lock Out configuration
Display Brightness
+Overload Signal
- Overload Signal
Resolution Overflow
Value Overflow in Setpoint/Menu Routines
Value Overflow in Setpoint/Menu Routines
Net Value Overflow
Gross Value Overflow
2 Coordinate Format Programming Error
Peak Value
Peak Reset
Tare Reset
Setpoint Reset
Net Value
Gross Value
Setpoint 1 Value
Setpoint 2 Value
Resolution Over Scale
Firmware Version (where 8 is 0 ~ 9)
Operating Mode