User's Manual
© Copyright 2022 Eaton Page 4 of 7
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils
radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes:
(1) l’appareil ne doit pas produire de brouillage;
(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si
le brouillage est susceptible d’en compromettre le fonctionnement.
6 4 RF Exposure Information
READ THIS INFORMATION BEFORE INSTALLING THE XPD2400A
This product is intended for mobile and portable installation applications.
XPD2400 complies with FCC (§1.1310)/ISED (RSS-102 part 4, table 4) RF Exposure
requirements for mobile applications, as shown in the RF Exposure Report. The mobile product
antenna must be installed in a manner that will provide at least 20 cm clearance between the
antenna and any user or member of the public.
XPD2400 was tested with the following antennas:
Table 1. Antennas used for emissions measurement
The XPD2400 was evaluated at 17.6dBm output power conducted, 53% worst case duty cycle.
The RF Exposure Evaluation showed that the maximum power density radiated by the antennas
used in mobile applications (antennas 1, 2 and 3 from table) is well under the maximum
permissible exposure (MPE) limits as specified in §1.1310 of FCC regulations and RF Field
Strength Limits in RSS-102 for general population/uncontrolled exposure at 20cm. The
calculations are done in XPD 2400 RF Exposure Report.
Table 2. RF Exposure Evaluation for Mobile Products
MPE Power Density
threshold for General
Population/ uncontrolled
Exposure FCC 47 §1.1310
RF Field Strength Power
Density threshold for General
Population/ uncontrolled
Exposure RSS-102
Maximum Power Density
created at 20 cm distance by
the Maximum Gain Antenna
(Type2) for a maximum duty
cycle of 53%
0.019
For portable applications XPD2400 is certified using for Wellshow rubber duck AR010-2.4GHz
and Yageo ceramic chip antenna ANT7020LL05R2400A.
Item
Description
Manufacturer
Model
Gain
1
2.4-2.5GHz 1/2l Dipole
Laird
TRA24003NP
3 dBi
2
2.4-2.5 Dual Closed Coil Whip
Pulse
NMO5E2400B
5 dBi
3
2.4-2.5GHz Edge Inverted L
Cooper
ACAB-2683-07
5.06 dBi
4
2.4-2.5GHz 1/2l Dipole
Wellshow
AR010-2.4G
2 dBi
5
2.4-2.5GHz SMD Ceramic
Yageo
ANT7020LL05R2400A
2.62dBi