OEM900MR User Manual and Installation Procedure Document Revision 1.0 November 16, 2007 © 2007 OMNEX Control Systems Inc. All rights reserved.
The OEM900MR transceiver module is not sold separately as a stand alone device. It is intended to be used as part of a complete OMNEX telemetry device and in the user manual for any device containing the module will be included the text from the following page.
This manual is for the use of professionals to guide them in the installation, operation and basic system maintenance of the equipment covered. Caution: OEM900MR complies with part 15 of the FCC Rules and IC Notice.
RF Exposure Information READ THIS INFORMATION BEFORE INSTALLING THE OEM900MR This product is intended for fixed installation applications. In order to comply with FCC/ISC adopted RF exposure requirements, installation of this transmitter system's antennas must be performed in a manner that will provide at least 8 inches (20 cm) clearance from the antenna to any user or member of the public. OEM900MR was certified with the following antennas: RAD-ISM-900-ANT-OMNI-0-6 (¼ Wave Whip Antenna with 1.8 m (6 ft.
