User's Manual

9
DM-R2160-0007A (Rev 1)
www.omnexcontrols.com
call toll free: 1-800-663-8806
Light Legend
Solid
Slow
Flash
Fast
Flash
Red
Light
Green
Light
Alternating Red
& Green Light
Yellow
Light
A.
ESTOP
FAULT LINK
STATUS
A. Supply power to the re-
ceiver. The (E-Stop) light
and the (Link) light will
come on RED and the
(Status) light will come on
GREEN
3. Power R2160
A. Hold CALIBRATE [INC]
switch.
B. Latch POWER switch [ON].
C. Release CALIBRATE [INC]
switch.
4. Power T2400 into Configuration Mode
NOTE: If left idle in Setup Mode for over 30 seconds, the receiver will time out. The (Link) light and (Status) light will flash RED rap-
idly. To return to Setup Mode, repeat step 5.
A. Press & hold [Setup] button
until (Status) light goes from
slow flash to fast flash
B. Release [Setup] button.
(Status) light goes to solid
GREEN, (Link) light turns off
ESTOP
FAULT LINK
STATUS Setup
Button
A.
ESTOP
FAULT LINK
STATUS Setup
Button
B.
5. Put R2160 into Setup Mode
6. Download ID Code
ESTOP
FAULT LINK
STATUS
A. Press CALIBRATE [INC]
B. (Link) light flashes GREEN.
Once complete, (Link) light
goes to RED as the trans-
mitter turns off
B.
B.
A.
r
C.
A.
Download ID Code (Use in case of Link Test failure)
NOTE: When downloading a new ID to a receiver, a safety feature requires that the transmitter be in close proximity to the receiver. This will pre-
vent a transmitter from accidentally reprogramming a different receiver in the area.
CALIBRATE INC
PWR ON
CALIBRATE [INC]
r
CALIBRATE INC
PWR ON
r
CALIBRATE DEC
PWR ON
r