User's Manual

8
DM-R2160-0007A (Rev 1)
www.omnexcontrols.com
call toll free: 1-800-663-8806
ESTOP
FAULT LINK
STATUS
Light Legend
Solid
Slow
Flash
Fast
Flash
Red
Light
Green
Light
Alternating Red
& Green Light
Yellow
Light
Follow these steps to download the transmitter’s unique ID Code into the receiver. This will allow the receiver to establish
a Radio link with a specific transmitter. Refer to Troubleshooting Chart #4 for Tips and Considerations
NOTE: It is necessary to download the ID code when replacing either the transmitter or the receiver.
Follow these steps to ensure that there is a Radio Link between the transmitter and receiver
Refer to the Light Legend below for diagram details
1. Unlatch the POWER [ON] switch.
ESTOP
FAULT LINK
STATUS
2. Power the R2160
ESTOP
FAULT LINK
STATUS
3. Power the T2400
If the (Active) light on the transmit-
ter is flashing and the (Link) light
on the receiver is flashing GREEN,
a link between the two exists.
The (E Stop) light and the (Link)
light will come on RED (provided
the transmitter is off), and the
(Status) light will come on GREEN.
The ORIGA System is now ready for use.
If the receiver's (Link) light does not become GREEN follow the steps under Download ID Code.
The cap is held on by two plastic tabs at
opposing sides, which can be unlatched as
shown using a screwdriver. Once the cap
is free, the R2160 can slide open.
Use a small slotted screwdriver to press the
Side Tabs inward.
ESTOP
FAULT LINK
STATUS
1. Opening the R2160
A. Be sure the transmitter is powered off.
2. Prepare T2400
Test the Transmitter / Receiver Link
Download ID Code (Use in case of Link Test failure)
NOTE: When replacing the receiver cover, ensure the cover snaps completely into place to create a weather proof seal around the
base of the receiver.
LED States
LED States
4. Power Off the T2400
Unlatch the POWER [ON] switch to shut off the transmitter.