User Manual

USER MANUAL
5-11
Register Name (Attributes) Description
S6
Retransmit Broadcasts
(read/write)
Setting this register causes the master radio to repeat every
packet that is to be sent by unassured (broadcast) delivery.
The radio will communicate on a four-hop cycle.
Valid Modes: Y, N (Yes, No)
Default: N (No)
S7
RF Band
(read/write)
This register determines which frequency band the radio will
use while hopping.
Valid Range: 1..4
Default Value: 1
S8..S9 Reserved
S10
RSSI
(read only)
This register contains the average signal strength of all
packets received by the radio (Note: Units are TBD)
S11
Link Status
(read only)
This register will contain a value of 1 if the radio has received
a good RF packet within the last 2 seconds, otherwise the
value will be 0.
S12
Master ID
(read only)
This register contains the ID code of the master for the radio
(Note: This applies to repeater/slave radio units only)
S13
Retries
(read/write)
This register contains the number of communication retries a
frame may undergo before it is discarded.
Default: 50
S14
Maximum Message
Wait
(read/write)
This register contains the maximum period of time (in tenths
of a second) that packetized data may be buffered without
being transmitted before the chain is flushed.
Valid Range: 0..255 (tenths of a second)
Default: 10 (one second)
S15
Network Table Flush
Timeout
(read/write)
This register contains the maximum period of time (in tenths
of a second) that the network table is to be kept before
flushing.
Valid Range: 0..65535 (tenths of a second)
Default: 12,000 (twenty minutes)
S16..S19 Reserved
S20
Baud Rate
(read/write)
Serial port baud rate. Changes to this register will take effect
on next power up of the radio.
Allowable Values: 300, 600, 1200, 2400, 4800, 9600,
19200, 38400
Default Value: 9600
S21
Data Bits
(read/write)
Serial port data bits per character. Changes to this register
will take effect on next power up of the radio.
Allowable Values: 7, 8
Default Value: 8
S22
Stop Bits
(read/write)
Serial port stop bits per character. Changes to this register
will take effect on next power up of the radio.
Allowable Values: 1, 2
Default Value: 1
S23
Parity
(read/write)
Serial port parity configuration. Changes to this register will
take effect on next power up of the radio.
Allowable Values: E, O, N. (Even, Odd, None)
Default Value: N (None)
S24
Handshaking
(read/write)
This register indicates whether the serial port is utilizing
hardware handshaking. Changes to this register will take
effect on the next power up of the radio.
Allowable Values: 0, 1, 2 (No handshake, HW Control,
Xon/Xoff)
Default Value: 0 (No handshake)
S25
Port Protocol
(read/write)
Serial port protocol configuration. Changes to this register will
take effect on the next power up of the radio.
Allowable Values: 0, 1, 2, 3 (None, MODBUS, Allen Bradley,
Custom1)