User Manual

T245 Control System Manual

Function Wire # 16-pin (24-5S)

M.S. Pin

Board References

Override Panel Upper Boom

RETRACT

17 P J10 pin 7 (R1300)

Override Panel Lower Boom LOWER 8 R J10 pin 8 (R1300)

Override Panel Lower Boom RAISE 7 S J10 pin 9 (R1300)

In systems which include a T247 or T47 Cable Remote, the 16-pin connector is

used for connection to the Cable Remote. However, in systems without a T247/T47, a

truck-mounted Emergency Override Panel must be provided; use either the old-style

Emergency Override Panel Interface Cable or the new Custom Emergency Override Panel

Harness to make connections from the 16-pin connector to this Panel.

The Emergency

Override Panel must provide a normally-closed Emergency-Stop button across pins

E and F.

The emergency-stop circuit must be closed to operate the machine.

The

Emergency Override Panel must also provide a momentary, normally-open contact

between pin B and pin G; this is the override button which the operator must press

and hold to override the T45 Radio Transmitter.

Pin B is also the common to all the

override switches (pins J through S). Pins C and D are not used for the Emergency

Override Panel.