User's Manual

6
4. Electrical Connections
The Receiver/Controller has two circular M.S. connectors for connection to your
chassis wiring. A 54-pin M.S. connector is used for power and function outputs. A 16-
pin M.S. connector is provided for connection to the T47 Cable Remote or Emergency
Override Panel. The following tables specify the assignment of each pin, with
corresponding markings on the circuit boards for reference. The wire numbers refer to
the old-style Output Cable and not the new Custom Output Harness.
Main Connector (Power and Functions):
Function Wire # 54-pin (32A10P)
M.S. Pin
Board References
Ground 48,38 A, AF J15 (R1300), J3 (S20)
Power for Electronics (Battery
Positive)
39 AG J12 (R1300), J1 (S20)
Power for Function Outputs (Batt. +) yellow
+green
B J14 (R1300)
Dump Valve Output (drives power out
when radio signal is being received
from transmitter)
49 C J13 (R1300), J2 (S20)
Engine START 24 D D2 (R1300)
Engine STOP 47 E D1 (R1300)
Winch DOWN 29 F 1+ (R1300)
Winch UP 25 G 1- (R1300)
Digger DIG 46 H 2+ (R1300)
Digger CLEAN 45 J 2- (R1300)
Lower Boom LOWER 5 K 3+ (R1300)
Lower Boom RAISE 14 L 3- (R1300)
Intermediate Boom EXTEND 23 M 4+ (R1300)
Intermediate Boom RETRACT 26 N 4- (R1300)
Upper Boom EXTEND 3 O 5+ (R1300)
Upper Boom RETRACT 22 P 5- (R1300)
Pole Guide/Platform LOWER 44 R 6+ (R1300)
Pole Guide/Platform RAISE 30 S 6- (R1300)
Boom Rotate CCW 6 T O1 (S20)