ALICE Quick-start guide HIGH-WALL DUCTLESS AIR CONDITIONING & HEATING SYSTEM FAN AUTO OPER AIR HEALTH X-FAN HUMIDITY FILTER TURBO HOUR ON/OFF 2 1 3 ON/OFF MODE 7 FAN 8 9 11 X-FAN TEMP TIMER TURBO SLEEP LIGHT ON/OFF button 2 MODE button 3 +/- button 4 FAN button 5 button 6 button 7 HEALTH SAVE button 8 X-FAN button 6 9 TEMP button 10 10 TIMER button 5 4 1 (Note: X-FAN is same with BLOW) 11 TURBO button 13 12 SLEEP button 12 13 LIGHT button Introduction for icons
Introduction for buttons on remote controller Note: ● After putting through power, air conditioner will give out a sound and operation indicator " " is ON (red indicator). You can operate the air conditioner through the remote controller. ● At ON status, after each pressing button on remote controller, the signal icon " " indicates the signal has been sent to air conditioner. ● At OFF status, display screen on remote controller displays set temperature.
Introduction for buttons on remote controller Note: For preventing cold wind, after starting up heating mode, indoor fan will blow fan afterdelaying 1-5min. (Details time is decided by indoor ambient temperature) Temperature setting range on remote controller: 60.8~86°F (16~30°C). Fan speed setting range: auto, low speed, medium speed and high speed. 3 "+" or "-" button ● After each pressing of "+" or "-" button, it can increase or decrease set temperature 33.8°F(1°C) .
Introduction for buttons on remote controller Note: When selecting " " with remote controller, it’s auto swing. Horizontal louver of air conditioner will swing up&down automatically at the maximum angle. When selecting " 、 、 、 、 swing. Horizontal louver of air conditioner will stop at that position as shown by the icon to swing. 6 button ● Press this button to start or stop left & right swing function. The remote controller defaults to simple swing condition.
Introduction for buttons on remote controller SAVE function: Under cool mode, press SAVE button and the unit will operate under SAVE mode. Dual-8nixie tube on remote controller displays "SE". Air conditioner will operate at auto speed. Set temperature can’t be adjusted. Press SAVE button again to exit SAVE mode. Air conditioner turn back to original set speed and set temperature. ● This function is applicable to partial of models.
Introduction for buttons on remote controller hour. When holding "+" or "-" button, 2s later, the time will change quickly until to Cancel TIMER OFF: Press "TIMER" button again under TIMER OFF status. ● At OFF status, press this button once can set TIMER ON. Please refer to TIMER off for detailed operation. Cancel TIMER ON: Press "TIMER" button again under TIMER ON status. Note: ● Time setting range: 0.5-24 hours. ● Time interval between two operations can’t exceed 5s.
KEY FEATURES & FUNCTIONS DEFROST FUNCTION This increases room comfort and saves energy by sensing the need for defrosting and eliminating unnecessary defrost cycles. SLEEP MODE You design a cycle to automatically adjust room temperatures during your sleep time, to maximize comfort and reduce utility bills. TURBO MODE This capacity boost function is the fastest way to reach a desired temperature setpoint, either in heating or cooling.
