ALICE Quick-start guide HIGH-WALL DUCTLESS AIR CONDITIONING & HEATING SYSTEM 2 4 ON/OFF button 2 MODE button 3 FAN button 4 SWING button 3 5 TURBO button 5 6 ▲/ 7 SLEEP button 8 TEMP button 9 I FEEL button 6 7 8 9 11 10 ▲ 1 1 button 10 LIGHT button 12 11 CLOCK button 12 TIMER ON/TIMER OFF button health function I feel Set fan speed Send signal Operation mode Turbo mode Auto mode Cool mode 46°F( 8°C) heating function Set temperature Dry mode Fan mode Set time TIMER ON/
Introduction for buttons on remote controller Note: ● This is a general use remote controller, it could be used for the air conditioners with multifunction; For some function, which the model doesn't have, if press the corresponding button on the remote controller that the unit will keep the original running status. ● After putting through the power, the air conditioner will give out a sound. Operation indictor " " is ON (red indicator).
Introduction for buttons on remote controller temperature. Press "FAN" button to adjust fan speed. Press "SWING" button to adjust fan blowing angle. (Cooling only unit won’t receive heating mode signal. If setting heat mode with remote controller, press ON/OFF button can’t start up the unit). Note: ● For preventing cold air, after starting up heating mode, indoor unit will delay 1~5 minutes to blow air (actual delay time is depend on indoor ambient temperature).
Introduction for buttons on remote controller 5 TURBO button Under COOL or HEAT mode, press this button to turn to quick COOL or quick HEAT mode. " " icon is displayed on remote controller. Press this button again to exit turbo function and " " icon will disappear. ▲/ ▲ 6 button ▲ ▲ ● Press "▲" or " " button once increase or decrease set temperature 33.8°F(1°C). Holding "▲" or " " button, 2s later, set temperature on remote controller will change quickly.
Introduction for buttons on remote controller ● It’s defaulted to display set temperature when turning on the unit. There is no display in the remote controller. ● Only for the models whose indoor unit has dual-8 display. ● When selecting displaying of indoor or outdoor ambient temperature, indoor temperature indicator displays corresponding temperature and automatically turn to display set temperature after three or five seconds.
KEY FEATURES & FUNCTIONS DEFROST FUNCTION This increases room comfort and saves energy by sensing the need for defrosting and eliminating unnecessary defrost cycles. SLEEP MODE You design a cycle to automatically adjust room temperatures during your sleep time, to maximize comfort and reduce utility bills. TURBO MODE This capacity boost function is the fastest way to reach a desired temperature setpoint, either in heating or cooling.
