User manual

40 www.cooperbussmann.com/wirelessresources
Cooper Bussmann 615M-1 Cellular Data Modem and IP Router Series Manual
Rev Version 1.0
PPTP
Click the PPTP tab on the Security page to configure Point-to-Point Tunneling Protocol (PPTP), a method for
implementing virtual private networks (VPN).
Figure 26 Security–PPTP
PPTP Client Configuration
PPTP Client Selecting “Enable” allows PPTP functionality. Selecting “Disable” turns off PPTP
functionality.
Set Default Route to
PPTP
Selecting “Enable” routes all IP traffic through the PPTP network. Selecting “Disable”
routes only PPTP traffic through the PPTP network.
PPTP Server The IP address of the virtual private network server on which to connect.
Username The user name required by the VPN server.
Password The password (associated with the user name) required by the VPN server.
PPTP Server Configuration
PPTP Server Selecting “Enable” starts the VPN server. Selecting “Disable” stops the VPN server.
Server Local IP The IP address that clients will use to communicate with the server after they
connect.
Client IP Range The pool of IP addresses assigned to clients.
Protocols Allowed Selecting a protocol will instruct the VPN server to accept clients who use that
protocol. The server rejects clients using any of the unselected protocols.
Encryption Selecting “Use MPPE” enables Microsoft Point-to-Point Encryption for
communication between the server and clients. This option requires the MS-CHAP or
MS-CHAPv2 protocol.