User manual

www.cooperbussmann.com/wirelessresources
Cooper Bussmann 615M-1 Cellular Data Modem and IP Router Series Manual
11Rev Version 1.0
Panel Indicator Connection Description
RESET
Hold for one second to reset unit. Hold for at least 4 sec to reconfigure
the unit to its factory default settings.
PWR Jack
Molex 43025-0400;
Power – bottom pins
Interface for power plug (9-28 Vdc)
Top pins are not available for use.
SIM/SVC
SIM Card socket
Interface for SIM card. Your wireless service provider will supply the SIM
card with your wireless service contract.
Table 5 Status LEDs
Function Off Green Flash Green Red Flash Red Amber Flash Amber
RSSI
Strong Weak/None Medium
SVC
3G 3G/NC NC 2G 2G/NC
NET
No Connectivity RX Data TX Data RX/TX
Aux
Disabled Good Failed
If SVC is solid on, the modem is connected to the Internet. If SVC is flashing, the modem is trying to connect to the
network. NET indicates the direction of data. At boot, the LEDs act differently than described in Table 5. The boot
sequence for LEDs is as follows:
All Red, All Amber, All Green, All Flash Green 3 times. Boot sequence is complete.
1.7 Antenna
The primary antenna connections are SMA female connectors, and must be used with antenna with SMA male
connectors. When using a direct mount or rubber duck antenna, choose the antenna specific to your band
requirements. Mounting options and cable lengths are user’s choice and application specific.
The AUX antenna connector is installed on all standard models and can be used for diversity. The diversity port
supports two bands, Cellular (850 MHz), and PCS(1900 MHz). Connect a dual band cellular antenna to this port to
implement RX diversity on the unit and increase receive sensitivity on the cellular network.
1.8 Power Cable Pinout
The 615M-1 ships with a 6 ft power cable that does not require a fuse. The ignition sense line should be shorted to
Vin/Vbattery.
Table 6
Pin Signal Color Mobile Color Fixed
1
VIN/VBatt Red Red
2
Ground Blue Black
3
Ignition Sense White White
4
No Connect NA NA