User manual

62 www.cooperbussmann.com/wirelessresources
Cooper Bussmann 2080E-T Managed Ethernet Switch User Manual
Rev Version 1.0
Figure 65 802.1X Radius - Configuration
IEEE 802.1x Protocol Enable or disable 802.1x protocol. When enabled, the configuration parameters
become available.
Radius Server IP Assign the RADIUS server IP address.
Server Port Set the UDP destination port for authentication requests to the specified RADIUS
server.
Accounting Port Set the UDP destination port for accounting requests to the specified RADIUS server.
Shared Key Set an encryption key for use during authentication sessions with the specified
RADIUS server. This key must match the encryption key used on the RADIUS server.
NAS, Identifier Set the identifier for the RADIUS client.
Quiet Period Set the number of seconds during which the port will not attempt to acquire a
supplicant.
TX Period Set the number of seconds that the port waits before retransmitting the next EAPOL
PDU during an authentication session.
Supplicant Timeout Set the number of seconds that the switch waits for a supplicant response to an EAP
request.
Server Timeout Set the number of seconds that the switch waits for a server response to an
authentication request.
Max Requests Set the number of authentications that must time-out before authentication fails and
the authentication session ends.
Re-Auth period Set the number of seconds after which connected clients must be re-authenticated.
Apply Click to apply the settings.