User manual

60 www.cooperbussmann.com/wirelessresources
Cooper Bussmann 2080E-T Managed Ethernet Switch User Manual
Rev Version 1.0
Figure 63 IP Source Guard - Configuration
IP Security Mode Enable or disable IP security. When security is enabled, the fields on this page
become active.
Enable Web
Management
When this checkbox is selected, any device whose IP address matches one of the
10IPaddresses in the Security IP1–IP10 table (see the next section) will be given
permission to access this switch via HTTP service.
Enable Telnet
Management
When this checkbox is selected, any device whose IP address matches one of the
10IP addresses in the Security IP1–IP10 table (see the next section) will be given
permission to access this switch via Telnet service.
Enable SNMP
Management
When this checkbox is selected, any device whose IPaddress matches one of the
10IPaddresses in the Security IP1–IP10 table (see the next section) will be given
permission to access this switch via SNMP service.
Apply Click to apply the settings.
Static Table
The system allows you to assign up to ten IP addresses for access security. When IP Security Mode is enabled on
the IP Source Guard Configuration page, only these ten IP addresses will be able to access and manage the switch
through the HTTP/Telnet/SNMP service.
To set up the IP address table, click the Static Table tab on the IP Source Guard Configuration page. (To display
this page, choose Security-->IP Source Guard-->Configuration.)
NOTE Remember to choose Maintenance-->Save Configuration, and then click “Save” to save the new
configuration. Otherwise, the new configuration will be lost when the switch powers off. See “6.7.1 Save
Configuration.”