User manual

36 www.cooperbussmann.com/wirelessresources
Cooper Bussmann 2080E-T Managed Ethernet Switch User Manual
Rev Version 1.0
NOTE If you also want the port event log to be sent to the Syslog server, be sure to set the triggers (link
up, link down, and both) in the Port Alert page (see “Port Alert”).
Figure 33 System Alert - Event
System Restart When enabled, the system will issue an alert to the system log server when the
device executes a cold start. It may take a minute after the cold start before the event
appears in the system log server.
Power Status When enabled, the system will issue an alert to the system log server when input
power to the switch becomes unstable.
SNMP Authentication
Failure
When enabled, the system will issue an alert to the system log server when SNMP
authentication fails.
Apply Click to apply the setting.
6.4.8 DHCP Server
Dynamic Host Configuration Protocol (DHCP) is a protocol for assigning dynamic IP addresses to devices on a
network. With dynamic addressing, a device can have a different IP address each time it connects to the network.
In some systems, the device IP address can change while it is still connected. DHCP also supports a mix of static
and dynamic IP addresses. Dynamic addressing simplifies network administration because the software keeps track
of IP addresses rather than requiring an administrator to manage the task. This means that a new computer can be
added to a network without manually assigning it a unique IP address.
DHCP Server Configuration
To configure the switch as a DHCP server, choose System-->DHCP Server-->Server Configuration.