User manual

www.cooperbussmann.com/wirelessresources
Cooper Bussmann 2080E-T Managed Ethernet Switch User Manual
13Rev Version 1.0
ChapTEr 3 - harDWarE INSTaLLaTION
This chapter describes how to install the 2080E-T Managed Ethernet Switch.
3.1 Installation Steps
1. Unpack the 2080E-T Ethernet Switch.
The DIN rail is screwed onto the switch by default. To wall mount the 2080E-T Switch, refer to “3.3 Wall Mount
Plate Mounting.”
2. Hang the switch on the DIN rail track or wall.
3. Power on the switch.
For information on wiring the power, see “3.4 Wiring the Power Inputs.”
When the switch is powered on, the power LED turns on. Refer to “2.3 LED Indicators” for information about
the LEDs.
4. Prepare the twisted-pair straight-through Category 5 cable for the Ethernet connection.
5. Insert one end of the RJ-45 (Category 5) cable into the Ethernet port (RJ-45 port) on the 2080E-T Switch and
insert the other end of the same cable into the Ethernet port (RJ-45 port) on the network device (a switch, PC,
or server).
The UTP port (RJ-45) LED on the 2080E-T will turn on when the cable is connected to the network device. See
“2.3 LED Indicators” for details about the LEDs.
NOTE Make sure that the connected network device supports MDI/MDI-X. If it does not, use the
crossover Category-5 cable.
6. When all connections are set and the LEDs all indicate status is normal, the installation is complete.
3.2 DIN Rail Mounting
The 2080E-T normally ships from the factory with the DIN rail mount kit installed. If the DIN rail is not installed, refer
to Figure 5 to screw the DIN rail onto the switch. Then, follow the steps to mount the switch.
Figure 5 Rear Side of 2080E-T Switch and DIN Rail