Submittal Sheet

Size Range:
3
/8"-16 rod, pipe sizes
1
/2" (15mm) thru 4" (100mm)
Material: Pre-Galvanized Steel
Function: Practical and economical bracket used to support piping from wood, con-
crete or steel beams.
Features: Unique design allows rod to be easily threaded into bracket. Offset design
permits unlimited rod adjustment. Center mounting hole will accept
3
/8" and
1
/2" fastener
bolts. Per NFPA 13:
1
/2" (15mm) thru 2" (50mm) pipe requires
3
/8" fastener, 2
1
/2" (65mm)
thru 4" (100mm) pipe requires
1
/2" fastener.*
Approvals: Underwriters Laboratories Listed in the USA (UL) and Canada (cUL), and
Factory Mutual Engineering approved thru 4"
(100mm) pipe.
Finish: Pre-Galvanized
Order By: Part number and finish
*Note: Additionally UL has listed the Fig. 58 with fasteners
as shown in table below.
Fig. 58 - Threaded Side Beam Bracket
A
C
2 -
1
/4" x 2" Lag Bolts
(No Pre-Drilling
Up to 4" (100mm) pipe
Per NFPA
1 -
3
/8" or
1
/2" Lag Bolts
Up to 4" (100mm) pipe
2 - #16 x 2"
Drive Screws
1
/2" (15mm) - 4" (100mm) pipe
Bolt & Hex Nut
Up to 4" (100mm) pipe
2 - #14 x 1" or
1
/4” x 1”
Tek Type Screws
Into Min. 16 Gauge Steel
Up to 4" (100mm) pipe
B
UL Listed Fastener Table
Pipe Size Qty Fastener Type Material
2" 2 #16 x 2" Drive screws Wood
2" 1
3
/8" Lag bolt Wood
2
1
/2" - 4" 1
1
/2" Lag bolt Wood
3
1
/2"2
1
/4" x 1
1
/2" Lag bolts Wood
4" 2
1
/4" x 2" Lag bolts ** Wood
4" 2 #14 x 1" or
1
/4" x 1" Tek type screws Metal (15 gauge)
4" 2 #14 x 1" or
1
/4" x 1" Tek type screws Metal (16 gauge)
** No pre-drilling
Part No. Pipe Size Rod AB CMax. Rec. Load Approx. Wt./100
in. (mm) Size in. (mm) in. (mm) in. (mm) Lbs. (kN) Lbs. (kg)
58
1
/2" - 4” (15 - 100)
3
/8"-16 2
3
/4" (69.8) 1
1
/2" (38.1) 1
1
/8" (28.6) 300*** (1.33) 14 (6.3)
*** With Safety Factor of 5.
Upper
Attachments
All dimensions in charts and on drawings are in inches. Dimensions shown in parentheses are in millimeters unless otherwise specified.
Upper Attachments
218
Pipe Hangers & Supports