Manualshelf

Instruction manual

ManualsBrandsCooper Atkins ManualsComputer equipmentNotifEye
12345678910
7
Contents Page
7. Current Sensor Information
Displays the most current information of the selected sensor, including: last check-in, signal strength,
battery power and last sensor reading.
8. Sensor Data Window
Select a tab to change between:
History - displays a history (in list form) of the sensor’s data.
Notications - allows you to view, add, edit or delete notications for the sensor.
Chart - displays a graphical view of the sensor’s data.
Export - allows you to archive data by exporting as a .csv le.
Edit - allows you to change congurations such as sensor name and heartbeat.
Note: The tab highlighted in green is your current selection.
9. Date Range Selector
Allows you to choose the date range for viewable information such as sensor history, notications
sent, charts and sensor data export.
Configuring Sensors
To set a sensor’s congurations, from the Sensor List, click the “Edit” icon next to the name of
the sensor that you would like to congure. Alternately you can click on the “Edit” tab in the Sensor
Data Window to access this same area. The Temperature Sensor Conguration window allows you
to set the primary congurations for each sensor. Within this window you can change the name of
the sensor, set the heartbeat (how often the sensor checks-in with the software - 120 minutes is
recommended), and change the unit of measurement. When you have nished making changes,
press the “Save” button at the bottom of this section.
Note: Be sure to click the “Save” button anytime you make a change to any of the sensor parameters. All changes made
to the sensor settings will be downloaded to the sensor on the next sensor heartbeat (check-in). Once a change
has been made and “Saved,” you will not be able to edit that sensor’s congurations again until the sensor has
downloaded the new setting.
Sensor Name
The name of the assigned sensor, e.g., Freezer 1.
Display As
Indicates whether temperature is displayed as °F or °C. Slide the grey bar to change between them.
8. Sensor Data Window
7. Current Sensor Information
9. Date Range Selector