Operating instructions

Revised: 03/12/2009 3/12/2009
12
5. Feed the gas line through the hole located at the lower right hand side of the outer weather
cover (provided) and the flue pipes through the pre-punched hole for the flue pipes on the
upper left hand side.
6. Fit the outer weather cover over the exposed heater body and screw to the outer wall. Also
use a silicon sealant.
7. Trim the inner flue to 50mm longer than the outer flue.
8. Fit the cowl back to the outer weather cover (Also use a silicon sealant). As page 10
instructions.
9. Fit the cowl to the flue pipes and then to the weather cover.
10. Install heater as instructions on page 10.
EXTERNAL WEATHER COVER
1. The weather cover has in the bottom RH corner a moveable plate for gas connections.
2. Pre punch holes to take cowl.
3. Weather cover must be sealed with silicone to stop water entry.
Note: when the weather cover and cowl are attached it is necessary to seal the top and
side edges with silicone to prevent water entry.