Operator's Manual

TREAT EVERY GUN AS IF IT IS LOADED...ALL THE TIME 15
Disassembly (cont’)
3) Pull SLIDE back until disassembly notch on SLIDE lines up with rear
end of SLIDE CATCH. The SLIDE CATCH is able to pass under the
SLIDE and out of the FRAME only at this point. Push against the
end of the SLIDE CATCH which projects from the opposite side of
the FRAME, above the trigger guard. With SLIDE CATCH pushed
to its fully downward position, withdraw catch.
Figure 3: Slide Catch Removal
Figure 2a: Slide Catch
Notch Alignment
Align Notch
Figure 2b: Slide Catch Notch
Alignment - Close Up
Slide Catch
Slide Align Notch