User Manual

Getting Started
Before plugging in the cooler/warmer unit: make sure the switch on the back of the unit is
set to the OFF setting.
A minimum 2" vent clearance is required for proper ventilation.
Plugging in your unit:
Turning on your unit:
1.
2.
3.
4.
5
For home application: use the supplied AC power cord (see Fig. 2) by inserting AC
connector into unit’s AC port (see Fig. 5) and inserting AC plug into wall outlet.
This unit works on 100-240V (in compliance with North American and
EU/UK standards).
For motor vehicle application: Car engine MUST be turned on first before plugging
in the cooler/warmer. This precaution pr
events a power surge that can lead to
the unit overheating and/or becoming a potential fire risk. Use the supplied DC
power cord (see Fig. 3) and insert DC connector into unit’s DC port (see Fig. 5)
and the DC plug into the appropriate cigarette-lighter outlet.
For Cooling: Set the power switch to the COLD setting. A green light will turn on
to indicate that the unit is in cooling mode.
For Warming: Set the power switch to the HOT setting. A red light will turn on to
indicate that the unit is in warming mode.
Fig. 5
Vents
HOT/COLD SWITCH
DC/AC SWITCH
DC PORT
AC PORT
Fig. 6
HOT
HOT
COLD
100-
240V
100-
240V