Operating Guide

Getting Started cont.
6
Fig. 7
32
POWER SET FROST
HEAT
UP DOWN
Turning on your unit:
Setting the Temperature:
2.
3.
Press the power button to turn it on (see Fig. 5)
NOTE: When you plug your Concord unit in, the first number you see displayed
(steady number) reflects the unit’s current internal temperature. This number will
go up or down depending on the internal temperature of the unit.
The Concord LDX has a temperature setting range from 16°F to 149°F.
To set your desired temperature, you must enter SET MODE.
To enter SET MODE: Tap the SET button. A flashing number appears—this is the
number you’re setting your desired temperature to.
To EXIT SET MODE: Tap SET button again or wait 5 seconds. (NOTE: the flashing set
number will be replaced by the unit’s internal temperature.)
When in SET MODE, use the UP and DOWN arrow buttons to set the flashing
number to your desir
ed temperature.
2.
Turning on your unit
3.
Setting the Temperature
For Cooling: The lowest temperature that can be set on the thermostat is 16°F. However,
this model is a thermoelectric unit and is dependent on ambient temperature.
Therefore, the unit's interior temperature can be set on the thermostat within the
specified range, but the unit may not reach the pre-set temperature. Please refer to
page 7 for more information. Most people prefer their food/beverages between 35°F to
40°F. Cooling Mode is activated when the green FROST button turns on. (NOTE: The unit
may take up to 5 minutes to switch from Warming Mode to Cooling Mode.)
For Warming: The highest temperature that can be set on the thermostat is 149°F. For
food safety, it is recommended that foods be kept at 140°F or warmer. Warming Mode
is activated when the red HEAT button turns on. (NOTE: unlike Cooling Mode, switching
to Warming Mode is instantaneous.)