User manual

35
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If you experience interference with reception (e.g.,
television), determine if this equipment is causing the harmful interference by turning the equipment off and then back on
to see if the interference is affected.
If necessary, try correcting the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for further assistance.
HAC
This phone meets the M3/T3 level rating.
This phone has been tested and rated for use with hearing aids for some of the wireless technologies that it uses.
However, there may be some newer wireless technologies used in this phone that have not been tested yet for use with
hearing aids. Therefore, it is important to experiment with the various features of this phone and in different locations
using your hearing aid or cochlear implant, to determine if you hear any interfering noise. Consult your service provider
or the manufacturer of this phone for information on hearing aid compatibility. If you have questions about return or
exchange policies, consult your service provider or phone retailer.
TIA safety information
The following is the complete TIA Safety Information for wireless handheld phones:
Exposure to Radio Frequency Signal
Your wireless handheld portable phone is a low-power radio transmitter and receiver. When ON, it receives and sends
out Radio Frequency (RF) signals. In August 1996, the Federal Communications Commissions (FCC) adopted RF
exposure guidelines with safety levels for handheld wireless phones. Those guidelines are consistent with the safety
standards previously set by both U.S. and international standards ‘bodies, as follows:
ANSI C95.1 (1992) *
NCRP Report 86 (1986)
ICNIRP (1996)
* American National Standards Institute; National Council on Radiation Protection and Measurements; International
Commission on Non-Ionizing Radiation Protection. Those standards were based on comprehensive and periodic
evaluations of the relevant scientific literature. For example, over 120 scientists, engineers, and physicians from
universities, government health agencies, and industry reviewed the available body of research to develop the ANSI
Standard (C95.1). The design of your phone complies with the FCC guidelines (and those standards).
Downloaded from www.Manualslib.com manuals search engine