Service manual

Replacing the Compressor

Compressor Replacement Procedure

139

Installation

• Install the compressor in the reverse order of removing of compressor.

NOTE:

After installation, fully open the valve at bottom side of the compressor, using a hexagonal

wrench.

Vacuuming

• Connect the vacuum pump to the check joint of the discharge and suction pipes, and

operate the vacuum pump.

• Perform vacuuming until the vacuum low-pressure gauge indicates 0.750 (mmHg).

Charging of refrigerant

Add refrigerant of the same volume to the recovered refrigerant into the check joint of the

liquid pipe.