Specifications

Init Rebuild: Defines whether to automatically copy (mirror) the contents of Disk 0 to
Disk 1 whenever a new SAFE volume configuration is created. When this policy is
“Enabled”, the data from Disk 0 will be automatically copied (mirrored) to Disk 1.
When this policy is “Disabled”, no automatic copy is performed.
Auto Rebuild: Defines whether to remember the non-usable state of a hard drive if it is
disconnected and then re-connected to the CoolMax CD-320 . When this policy is
“Enabled”, the system will always attempt to rebuild a disk that has been inserted,
even if that disk had previously been identified as non-usable. When this policy is
“Disabled”, the system will not rebuild a disk that had previously been identified as
non-usable.
Verify Rebuild: Defines whether to automatically perform a verification of the data after
a rebuild operation is completed. When this policy is set to “Enabled”, a verification
of the copied data is automatically performed. When this policy is “Disabled”, an
automatic verification of the copied data is not performed, and any verification would
need to be launched manually through the SteelVine Manager GUI.
These settings are based on the hard-strapping of GPI pins 5, 6 and 8 and cannot be modified
through the SteelVine Manager GUI.
Accessing the Policy Settings Dialog
Use the following procedure to open the Policy Settings Dialog.
1. Click on the Policy Settings icon along the top of the SteelVine Manager Status window.
Note: This selection is only available when at least one SAFE volume exists.
2. When prompted, enter the administrator password. The default password is admin.
3. The Policy Settings dialog shown below will appear.