Instruction Manual
Table Of Contents
LEAK TESTING OPERATING INSTRUCTIONS
GENERAL
Although the gas connections of the appliance ar e leak tested prior packing and shipment. a completetest must be performed at the
installa tion site.
Before each us e, check all the gas connections for leak testing using the procedure listed below.lf the smell of gas is detected at any time,
you should imm ediatelystop using and check the entire system for teaks.
BEFORE TESTING
Mak e sure all packing material has been removed from the appliance.
Mak e a solution of one part liqui d detergent and one part water. You will need a spray bottle, brush or rag to apply the solution to the
fittings.
TOTEST
1.
Turn the burner valve
OFF
2.
Turn the liquid propane cylinder valve on counterclockwise to open the valve.
3. Apply the soap solution to all gas fittings. Soap bubbles would appear where a leak is present.
4. lf a leak is pr esent. immediately turn the gas supply
OFF
and tighten leaky fittings.
5. Turn the gas back
ON
and recheck.
6. Should the gas continueto leak from any of the fittings, turn the gas supply
OFF
and contact customer service.
USING THE OVEN
Each bur ner is rated at 4.0KW. To begin:
1.
Mak e s ure the oven has been leak tested and properly placed.
2. Removeany remaining packing material.
3. Light the burner using the LIGHTING INSTRUCTIONS below
LIGHTING INSTRUCTION
TO LIGHT THE BURNER
1.
Mak e sur e the control knob is in OFF position, and then turn the liquid pr opane cylinder valve ON by
slowly
turning
co
unterc
o
l
ckwis
e.
2.
Push in and slowlyturn the control knob anticlockwise until you hear a click and the burner ignites.
3. lf burner does nSt light. turn the knob OFF, wait 5 minutes and repeat the lighting.
TO LIGHT WITH A MATCH
1.
lf burner will not light after several attempts using the control knob,the burner may be lit with a
match.
2. lf you have already attempted to light the bur ner using the control knob, wait 5 minutes for any gas to dissipate.
I
n
ser!
a
mat
c
h
into
the
m
a
tchst
c
i
k
h
older
,
ignite
the
match
and
inser!
through
the
ove
n
ope
ning
to
the
burner.
4. Push and turn the control knob to HI slowly, the bur ner should ignite immediately.
5. Il the bur ner does not light within seconds, turn the control knob OFF and wait 5 minutes and try again.
CARE AND MAINTENANCE
Store NL-P200 out of direct sunlight and indoors where possible and when storing for extended periods of time. NL-P200 shouldnot be
exposed to harsh weatherconditions such as snow, heav y rain and strong winds.
Wait for NL-P200 to cool completely beforemoving
The outershell of NL-P200 may fade over time and through use. This will not affect performance.
STONE BAKING BOARD
1.
DO NOT use the stone over an open flame
2. Avoid extreme temperaturechange to the stone. DO NOT place frozen foods on a hot stone
3. The stone is fragile and can break if bumped or dropped
4. The stone is very hot during use and stays hot fora long time after use.
5. DO NOT cool the stone with water when the stone is hot
6. Alter cleaning the stone with water, please dry the stone before us e. This can be done in a conventional oven at 60'C {140' FI for 2
hours.
6 7
..
_)