Instruction Manual

The parts which have been sealed by the manufacturer should not be adjusted by the user
Whenthe appliance is using LPG A LPG cylindershould be used
The LPG cylinder size: max diameter-350mm, max height-400mm.
The appliance is to be installed with sufficientventilation to prevent the occurrence of unacceptable concentrations of substances
harmful to health in the room in which the appl iance is install ed
The minimum distances between the appliance and adjacent walls is 0.5m
The hose for the appliance should not exceed 1.5m
The app liance should be installed in a suitablyventilated room. Permanent supply of fresh air is ensuredand there is no accumulation
of unburnedgases
The
gas
supply
tub
ing
or ho
s
e
shall
comply
wit
h
the
n
a
tion
al
require
ment
s
in
f
orce
and
s
h
all
be
period
ica
ll
y
ex
a
min
ed
and
r
epla
ced
as
necessary.
The hose should comply with the standard EN16436. The regual tor should complywith the standard EN16129.
The hose and regulator assembly may not be provided with the appliance in some regions.
Check and suitably clean the inside of the oven before it is lit in order to avoid the emission of tire from the oils that have accumulated
during previous cooking.
The burner outlets should be checkedfor obstruction during previous cooking.
The burner outlets should be checked for obstruction and cleaned regularl y with a soft wire brush.
It is necessary to avoid obstruction and to allow for a good combusti on
The position of the connection flexible tube so as to ensure that it is not subjected to twisting.
BEFORE LIGHTING
lnspect the gas supply hose prior to turning on the gas. lf there is evidence of cut. wear or abrasion, it must be replacedprior to use.
Screw the reg
ulator onto the gas cylinder. Leak check the hoseand regulator connections with a soap and water solution before lighting
the appliance.
it
LP
GAS CYLINDER WARNING
1.
Do not store spare liquid propane gas cylinder under or near this appliance.
2.
Never till the cylinder beyond 80 percent capacity.
3.
Liquid propane cylinder must be titted with an OVERFILL PROTECTION DEVICE (OPD).
4.
lf the information above is not followedexactly, a tire resulting in death or serious injury may occur.
SAFETY PRACTICES TO AVOID INJURY
When properly cared for, your oven will provide safe, reliable service for many years. However, extreme care must be used as the oven
produces intense heat that can increase the risk of accidents.
When using this oven basic practices must be followed,including but not limited to following:
Do not repair or replace any part of the oven unless specitically recommended in this manual. All otherservice should be referred to a
qualitied technician.
Children should not be left alone or unattended in an area where the oven is being used. Do not allow children to sit. stand or play
around the oven at any time.
Never let clothingor other flammables comein contact with or too close to any burner or hot surfac e until it has cooled. The fabri c
could ignite, causing serious personal injury.
For personal safety, wear proper apparel. Loose fittings garments or sleeves should never be worn whileusing the oven. Some
synthetic
fabrics are highly flammable and should not be worn while cooking.
Do not heat unopenedfoodcontainersas a buildup of pressure may cause the containers to burst. Whenlighting the burner,always
pay close attention to what you are doing.
When using the oven, do not touch the outer shell, stone baki ng board or immediate surroundings as these areas become extremely
hot and could cause burns.
Do not use the oven to cook extremely fatty meats or otherproducts which increaseflare-up.
Keep the area surroundings the oven free from combustible material including fluids , trash and vapours such as gasoline or charcoal
lighter fluid.
Do
not ob
s
tru
c
t
the
fl
ow
of
combustoi
n
and
ventil
a
tion
air.
Never use the oven in extremely windy conditions.
The temperature under the oven is high. Do not place the oven on a table with flammable table cloths, plastic or any other
inflammable materials.
PARTS LIST
1.
PIZZA O
ven
2.
Stone baki
ng board
1.
ASSEMBLY
Before assembly, make sure all parts are present. lf any part is missing or damaged, do not attempt to assemble the appliance. Contact
customer service for replac ement parts.
1.
Unfold legs
2.
Inser! the stone baking board
2