Full Product Manual

Network Camera Installation Manual

Fig 2.2a Fig 2.2b Fig 2.2c

Fig 2.2d

2.2 Add camera

There are 3 ways to add camera to the app: Lan Search, QR Code Scan and

Manual input.

Factory default user name is “admin” default password is “admin”.

Please note that the password on some models are empty. In this case, leave the

password section empty and proceed to complete the adding procedure.

Fig 2.2e

Fig 2.2f

Method 1:Tap“ ” to add cameras, then tap Search network. This will find all the

cameras in the same network. By selecting camera from the search list, it will

automatically add the Camera ID and Username in the system. Then name your

camera by your choice and input factory default password. Once all of the information

have been added, tap “Done” on the right top corner to finish adding process.

Method 2:Tap“ ” to add cameras, then tap Scan QR code. This will bring up a

camera scan on your screen so that you may find and scan the QR code which will

automatically add the Camera ID and Username in the system. The QR Code, which

looks like a square barcode (refer to 3rd picture below), can be found on the sticker

located at the bottom of the camera. Then name your camera by your choice and input

factory default password. Once all of the information have been added, tap “Save” on

the right top corner to finish adding process.

Add D evice