Full Product Manual

INSTALLING YOUR COOLBOT PRO

Watch our CoolBot Pro Installation Video at www.storeitcold.com/support

CONNECTING YOUR COOLBOT PRO TO YOUR WI-FI NETWORK

IMPORTANT

A Wi-Fi with Internet connection is required in order to access and use the CoolBot Pro App

CoolBot Pro and CoolBot Jumper Set Up

STEP 1 Unpack the CoolBot Pro in an area with good Wi-Fi reception (outside of your cooler). Plug in the

Temperature Sensors and the Heater Cable into the corresponding ports (See diagram on page 11). Don’t

connect the cables to your A/C and don’t plug in the power supply.

STEP 2 Connect the CoolBot Jumper to the CoolBot Pro using ONLY the provided silver/grey Data Cable. The

provided Data Cable is specific to the CoolBot Pro/Jumper – standard phone cable will not work and may

damage your CoolBot Pro/Jumper.

STEP 3 In an area where your PC or phone gets good Wi-Fi reception, plug in the CoolBot Pro’s Power Supply. You

should see codes and flashing mode lights for several seconds. These should settle down to one flashing

Program light, and the code “E0” alternating with the current room temperature.

Wi-Fi Configuration and Web App Set Up

STEP 4 Start the CoolBot Pro App by scanning the QR Code on your smartphone or go to the

web page https://cb.storeitcold.com on a device that has Wi-Fi (PC, tablet, phone,

etc.).

STEP 5 On the first screen, fill in your email address, create a password and select “Create

New Account”. The email address will be used for notifications, as well as to link your

data to your account.

STEP 6 Continue to follow the prompts. The App will guide you through configuring the CoolBot Pro to talk to the

CoolBot server using your Wi-Fi Network. When prompted, you will need to change the Wi-Fi settings on

your device (PC, Tablet, Phone, etc.) to connect to the Wi-Fi Network called “CoolBot”. On most smartphone

use Settings > Wi-Fi and on most PCs use the network or Wi-Fi status icon.

STEP 7 Choose or type in the Wi-Fi Network you want the CoolBot to use. This is usually the same network your

phone uses, but it can be a different network if you prefer. Enter the Wi-Fi password for the network and

press Next.

STEP 8 Once the CoolBot Pro is connected to the Network, you should see no codes (and no flashing) on the

CoolBot Pro display. If your device did not automatically switch back to your usual Wi-Fi settings use the

method outlined in STEP 6 to switch them back. You should now see temperatures on the app.

STEP 9 Press the “Refresh” button on your browser screen. You should now see temperatures on the app. You

are all set up! Unplug your CoolBot Pro from the power supply and proceed to “INSTALLING YOUR

COOLBO PRO TO YOUR A/C” Section of this guide (p.9) and then to THE COOLBOT PRO APP Section (p.13)

to learn about the amazing features of your web base app.