Full Product Manual

BEFORE INSTALLING YOUR COOLBOT PRO

• Should I read this manual? Yes! We highly recommend reading this manual entirely to familiarize yourself

with the new CoolBot Pro, with the CoolBot Pro App, and to ensure proper installation.

• What if I don’t have Internet OR Wi-Fi? No problem! You can still use the CoolBot Pro without the CoolBot

Jumper and without a Wi-Fi connection just like the previous generation CoolBots. Go straight to the

“INSTALLING YOUR COOLBOT PRO TO YOUR A/C” Section of this manual (page 9). NOTE: Your CoolBot Pro

will keep your cooler cold but you won’t be able to access data or change settings from the CoolBot Pro App.

• I have an Internet connection AND Wi-Fi. Awesome! Then you will enjoy all of the benefits of the CoolBot Pro

and its App. Start with “CONNECTING YOUR COOLBOT PRO TO YOUR WI-FI NETWORK” Section of this manual

(page 8) and then move to the “INSTALLING YOUR COOLBOT PRO TO YOUR A/C” Section of this guide (page

9).

• I am replacing my existing CoolBot with the new CoolBot Pro. No biggie! To ensure your cooler will continue

performing just as well as always grab a pen and write down the settings from your old CoolBot:

✓ Room Set Point: _______

Push either arrow key on your CoolBot until the Room Mode light is lit. Press

the checkmark and the current setpoint will blink.

✓ Fins Setting: _______

Push either arrow key on your CoolBot until the Fins Mode light is lit. Press

the checkmark and the current Fins Setting will blink.

✓ Heater delay: _______

Push either arrow key on your CoolBot until the Heater Mode light is lit. Press

the checkmark three times and the current Heater Delay Setting will blink.

Please go through the following checklist before installing your CoolBot Pro:

❏ The A/C Unit:

❏ Has digital display only.

❏ Has Automatic Restart.

❏ Is properly sized in BTUs. To check A/C sizing visit: https://www.storeitcold.com/support

❏ Is a recommended model. To check A/C compatibility visit: https://www.storeitcold.com/support

❏ The A/C is installed:

❏ High up on the cooler wall (bottom of the A/C above 5 feet/1.5 meters).

❏ On a short wall if it is a rectangular room.

❏ Tipped backwards (about 1 inch) and level from side to side to allow for proper draining.

❏ The Room:

❏ Ceiling and walls are insulated to R25 using Rigid Foam or Spray Foam (NO fiberglass batt

insulation!).

❏ Seams, corners and door gaskets are tightly sealed.

❏ Is airtight. When I close the door of my room (standing inside), I see no light through any cracks.

❏ Floor is insulated (only if it’s a mobile cooler, trailer, container, deck, raised floor, or if trying to cool

below 38°F/3°C).