Full Product Manual

Rev: 2019 – 1A ©2019 Store It Cold, LLC 6
HOW DOES THE COOLBOT PRO WORK WITH YOUR A/C?
The CoolBot Pro uses 2 temperature sensors (ROOM and FINS), the HEATER cable (red tip) and a programmed micro-
controller to direct your air conditioner to operate in such a way as to cool the room to a set temperature in between
33°F/0.5°C and 65°F/18°C without freezing up.
How does it do this?
The HEATER cable (red tip) is keeping your A/C’s sensor warm to make the A/C “think” it is warmer than the actual
room temperature. By doing this, the compressor on your A/C keeps running and cools down the space.
The ROOM and the FIN sensors tell the HEATER when to stop running. When the HEATER turns off, the A/C’s sensor
cools down and shuts off the compressor in response.
If the room temperature reaches the set value, the HEATER will stop running. Your A/C’s Temperature sensor will cool
down and shut the compressor off.
If the fins of your A/C are reaching the freezing set point (33°F factory default), the HEATER will stop running. Your
A/C’s Temperature sensor will cool down and shut the compressor off to allow for a defrost cycle. This is normal even
if the room has not reached its set point.
A slowly blinking Heater Activity Light is completely normal during operation.
It indicates that the CoolBot is “Calling for Cooling and the Heater Cable is getting hot.
The defrost cycle of the A/C does not use heat;
it defrosts by turning your compressor off and circulating air over the frosted coil.
HOW DOES THE JUMPER WORK WITH YOUR COOLBOT PRO?
The Jumper is the “middle man” in between your CoolBot Pro controller and your Wi-Fi Network. It allows the CoolBot
Pro App to receive data from the controller and vice versa. The Jumper does not need batteries. It gets power through
the Data Cable from the CoolBot Pro controller.
IMPORTANT!
An available Wi-Fi Network is required for the Jumper to operate. Mount the Jumper outside of your cooler in a
place where you have a strong Wi-Fi signal.
Connect your Jumper to the CoolBot Pro using ONLY the supplied Data Cable.
NOTE: The CoolBot Pro can still work to cool your room without the Jumper. Just install the CoolBot Pro without the
Data Cable and without the Jumper connected to it. Your CoolBot Pro will keep your cooler cold but you won’t be able
to access data or change settings from the CoolBot Pro App.