Manualshelf

Full Product Manual

ManualsBrandsCoolBot ManualsGarden CenterGeneration 7 WiFi Walk-In Cooler Controller with Air Conditioner Control from 59F to 34F
12345678910
Rev: 2019 – 1A ©2019 Store It Cold, LLC 5
DISPLAY:
The display changes depending on which Mode Indicator Light is illuminated.
MODE INDICATOR LIGHT:
Shows which mode you are currently using.
Change modes by pressing the left or right arrows.
Room Mode: While in normal operation, the display shows the current room temperature and the Room
Mode Indicator Light is solid (no blinking).
Fins Mode: From the Room Mode, press the right arrow once to access the Fins Mode. The light above “Fins”
will turn on solid (no blinking). The display will show the current fins’ (A/C’s coil) temperature.
Heater Mode: From the Room Mode, press the right arrow twice to access the Heater Mode. The light above
“Heater” will turn on solid (no blinking). The display will show an “F” for Fahrenheit or a “C” for Celsius.
Program Mode: From the Room Mode, press the right arrow 3 times to access the Program Mode. The light
above “Program” will turn on solid (no blinking). The display will show a number (e.g. 7.8), which will be the
firmware version on your CoolBot Pro.
POWER INDICATOR LIGHT: This light is constantly on (solid), as long as your CoolBot Pro is plugged in and getting the
correct power supply (110V-230V).
HEATER ACTIVITY INDICATOR: When the CoolBot Pro is “calling for cooling” this light will blink slowly. It will stop
blinking if the room temperature has reached the “set point” or the fins are reaching the freezing set point.
INPUT TOUCH KEYS
CHECKMARK KEY: Press to enter the setup menu, save values, and exit each particular mode.
RIGHT ARROW KEY: Press to move the Mode indicator light in between modes from left to right.
LEFT ARROW KEY: Press to move the Mode indicator light in between modes from right to left.
ROOM AND FIN SENSOR CABLES: These two cables are interchangeable. They monitor the room temperature and the
A/C’s fin temperature.
DATA CABLE: This cable connects your CoolBot Pro and your Jumper.
HEATER CABLE: This cable (red tip) heats up the A/C’s temperature sensor when cooling is needed.
POWER CORD: This standard Mini USB cable brings power to your CoolBot and the Jumper.
JUMPER: This is a radio signal device that connects your CoolBot to your Wi-Fi and to the Internet.
WI-FI STATUS: Flashes when a message has come in from the server - from the Internet.
DATA STATUS: Flashes when data is received from the CoolBot Pro controller.