Full Product Manual

Rev: 2019 – 1A ©2019 Store It Cold, LLC 25
PROPER INSTALLATION AND SETTINGS
• Make sure your A/C is on “COOL” Mode and the Fan on “HIGH”
• Make sure your A/C is a compatible brand. Check compatibility at: https://www.storeitcold.com/support
• Make sure that the A/C is draining properly.
The back of the A/C should be a lower (about 1 inch) than the front (inside) and the unit should be level from
side to side, so condensation can drain out the back. This is very important!
• Check the insulation around your A/C opening. This is a critical point in your Cooler for condensation.
• Make sure your A/C unit does NOT have a Secondary Sensor.
If the cooler is stuck around 45-50⁰F/7-10⁰C, or if the compressor comes off and does not cycle ON back for
a while, or if it cools down and then waits a long time to start cooling again, look for a Secondary Sensor on
your A/C (See INSTALLING YOUR COOLBOT STEP 6, page 10).
NOTE: This can happen even if your A/C has been installed for some time and was working correctly before
– please ensure your A/C does not have a secondary sensor if you are experiencing these problems (See
INSTALLING YOUR COOLBOT STEP 6, page 10).
FOR TROUBLESHOOTING AND QUESTIONS
Visit our support page at https://www.storeitcold.com/support
Or contact us at [e-mail]
DOUBLE YOUR WARRANTY!
We’d love to hear how your CoolBot is doing and learn more about how you are using it. Just fill out our Testimonials
Form online, and as a way to say “Thanks!”, we will double your CoolBot Pro warranty from 1 to 2 years!
You can find the Testimonials Form at: https://www.storeitcold.com/welcome/
FOLLOW US:
https://www.storeitcold.com
https://www.facebook.com/thecoolbot
https://www.instagram.com/storeitcold
https://twitter.com/storeitcold
https://www.youtube.com/storeitcold