Full Product Manual

Rev: 2019 – 1A ©2019 Store It Cold, LLC 24
CHECKS ON YOUR COOLBOT PRO
MY COOLBOT PRO HAS A BLANK DISPLAY BUT THE POWER LIGHT IS ON
The most likely cause is that your CoolBot is in Sleep mode. Either press any button on the CoolBot Pro, or change
the Power setting on the Devices tab in the app.
MY HEATER DOES NOT SEEM TO BE WORKING
Checking the HEATER is very simple:
● Pull the HEATER out of the aluminum foil. Hold the red tip against the inside of your wrist with your fingers.
● Unplug the POWER to the CoolBot, then plug it back in. In ~5 seconds the Heater Activity Indicator light will
come on SOLID for about 20 seconds.
● The HEATER should get Warm/Hot within the first 10-30 seconds of the CoolBot being plugged in. If not,
unplug/plug the HEATER a couple times and repeat the test.
● If it STILL doesn't get warm contact us at [e-mail].
NOTE: During normal operation, the Heater light blinks and you may not feel the warmth.
TEMPERATURE SENSORS CALIBRATION TEST
Checking the Calibration of your sensors is very simple:
● Gently slip the Fins Sensor tip out of the fins of the A/C. Let the tip of the sensor hang right next to the tip of
your Room sensor cable.
● Allow 2 minutes for the sensor to adjust its temperature reading.
● Compare the Room temperature reading with the Fins temperature reading using the arrows to toggle back
and forth between the Room Mode and the Fins Mode.
● Your Room Sensor and your Fins Sensor should read within 3 degrees of each other. If one of the sensors is
more than 3 degrees away from the other, compare the readings against a calibrated external thermometer
and replace the faulty sensor.
CHECKS ON YOUR A/C UNIT
DIRTY FINS
• This is a very common problem! Dirty front fins drastically reduce cooling power and waste electricity. Clean
the fins 2 times a month.
• Use a plastic brush with bristles long enough to go all the way through the fins. Depending on the make of
your A/C, a dish brush or paintbrush might work well.
• Use plain water. DO NOT use soap! Soap residue attracts more dirt!
• Dunk bristles in water then swipe down the fins. Rinse the bristles in the water and repeat, working your
way across until all the fins have been brushed. Change out the water as needed if it gets murky.
• A/C supply stores also sell “Foaming Coil Cleaner”.
• Squished fins greatly reduce the cooling power of the A/C. Use a “Fin Comb” (available at most hardware
stores) to straighten them.
• Fins on the back side (outside the cooler) should be cleaned at least once a year. Also, make sure no leaves
or debris are blocking the vent louvres of your A/C on the back.