Manualshelf

Full Product Manual

ManualsBrandsCoolBot ManualsGarden CenterGeneration 7 WiFi Walk-In Cooler Controller with Air Conditioner Control from 59F to 34F
11121314151617181920
Rev: 2019 – 1A ©2019 Store It Cold, LLC 12
CHANGING SETTINGS ON THE COOLBOT PRO
The CoolBot will always remember all your last settings even if it has been unplugged for a long time.
ROOM TEMPERATURE SETTING
This setting is the average temperature you want in your cooler.
NOTE: The factory default temperature is set at 42°F/5.6°C.
To set a new value for the Room temperature:
● Make sure the Mode indicator light is in the Room position (Room Mode).
● Press the checkmark ✓ button. The “set-temperature” will blink on the display.
● Use the arrow buttons to increase or decrease the temperature.
● Press the checkmark ✓ button to program (save) your new setting into memory.
● The display will go back to Room Mode showing the current room temperature.
FINS SETTING
This setting adjusts the sensitivity of the FINS Sensor to prevent freeze ups.
NOTE: The factory default setting is “1.”
Adjust this setting ONLY if you are experiencing icing problems.
A higher setting is more “conservative.” Some users need to bump up to “3” or “4” to keep from icing up.
95% of CoolBot installations work well with settings in the GREEN zone.
SETTING
0
1
2
3
4
5
6
7
8
9
To adjust the Fins setting:
● Press the right arrow until the Mode indicator light is in the Fins position (Fins Mode).
● Press the checkmark ✓ button. The current Fins setting will blink on the Display.
● Press the left/right arrow to lower/raise the setting value.
● Press the ✓ button again to save your new setting into memory.
● The display will go back to the Fins Mode and after 20 seconds of inactivity it will go back to the Room Mode.
HEATER DELAY SETTING
This setting allows you to increase or decrease the defrost cycle time.
NOTE: The factory default Heater Delay setting is “d1”
If you are experiencing ice ups and the problem has not been solved by increasing your Fins setting, then raise your
Heater Delay setting.
95% of CoolBot installations work well with settings in the SHADED zone.
SETTING
d1
d2
d7
d8
To change the Heater Delay setting:
● Press the right arrow until the Mode indicator light is in the Heater position (Heater Mode).
● Press the checkmark ✓ button 3 times. The current Heater Delay setting will blink on the display.
● Press the right/left arrow to increase/decrease the value of the setting.
● Press the checkmark ✓ button to save your new setting into memory.
● The display will go back to the Heater Mode and after 20 seconds of inactivity, it will go back to the Room
Mode.