Full Product Manual

STEP 4 Find and free your A/C’s Temperature Sensor. It’s the only thing attached to the front fins/grill of your air

conditioner.

On Mini Split air conditioning units this sensor is often not in front of the fins of the indoor unit. It may be

tucked into a plastic cover underneath or to the side of the unit. For pictures and examples of Mini Split

installations please visit our library section at: www.storeitcold.com/support

If your A/C has a clip built into the sensor to hold the sensor in the fins, remove the sensor from the clip

and free it enough to reach the side of the A/C - DO NOT use the mounting clip for this installation

STEP 5 Using ONLY a 2” square piece of Aluminum foil, place

the CoolBot Heater Cable (red tip) next to the A/C’s

Temperature Sensor (from STEP 4).

Keep together next to each other, pointing in the

same direction, and wrap them tightly with the foil.

Make sure they are away from the fins & flow of the air

and hang free, not touching anything cold or metal.

You can put a wire tie or zip tie around the 2 cables (1

inch before the foil) to keep the cables from getting

pulled apart.

STEP 6

IMPORTANT!

If your A/C has a Secondary Sensor, IT MUST BE UNPLUGGED.

➢ Window LG (except Inverter models) and window HAIER units DO NOT have Secondary Sensors (skip to STEP 7).

➢ Most GE, Danby, Frigidaire, Arctic King, etc. A/C units over 10K BTUs have a Secondary Sensor.

➢ All “Mini-Split” air conditioners have Secondary Sensors.

Use just 1 layer of electrical tape to attach the end of the Secondary Sensor to the OUTSIDE of the aluminum foil

connection from STEP 5. See picture below.

For videos and pictures on how to locate the secondary sensor go to: https://www.storeitcold.com/support

Main A/C Sensor

Secondary A/C Sensor