Manualshelf

Full Product Manual

ManualsBrandsCoolBot ManualsGarden CenterGeneration 7 WiFi Walk-In Cooler Controller with Air Conditioner Control from 59F to 34F
12345678910
Rev: 2019 – 1A ©2019 Store It Cold, LLC 9
IMPORTANT!
If you ever need to adjust the Data Cable or CoolBot Jumper placement, unplug the CoolBot Pro before
connecting or disconnecting the Data Cable.
INSTALLING YOUR COOLBOT PRO TO YOUR A/C
ATTENTION!
We understand how important this investment is for you, and we understand the value behind the product that you
will store in your cooler. We highly recommend that you read your A/C and CoolBot Pro installation manual, follow
the setup guide step by step, and familiarize yourself with the use and troubleshooting of the CoolBot Pro as well as
your A/C unit.
After installing your CoolBot, we strongly advise you to run your cooler for a test period (at least 24 hours) and place
some buckets of water or non-perishables to add mass. This is to assure the system is performing correctly and to your
needs.
If you are installing your CoolBot Pro to a Mini Split air conditioner system please use this step by step guide
along with our Mini Split Installation Guide available at our library at: www.storeitcold.com/support
STEP 1 Plug the cables into the corresponding labeled ports at the bottom of the CoolBot Pro except for the Data
Cable.
Plug the cables in and out a couple times as sometimes they don't “seat” all the way the first time.
If you are replacing an existing CoolBot with removable Temperature Sensors and Heater Cables, you can
leave them in place and connect them to the CoolBot Pro.
The CoolBot Pro works with both black and blue Temperature Sensor Cables.
The Room Sensor should hang free in the room.
STEP 2 Mount the CoolBot on the wall next to the control panel side of the A/C to make it easier to connect the
cables.
CAUTION! Make sure the wall fasteners are smaller in diameter than the hole in the CoolBot Pro tabs or
you will break the plastic tabs.
STEP 3 Remove the air filter from the front of the A/C unit. DO NOT use it!
The filters drastically reduce cooling power and increase your chances of icing up.
Clean your fins two times a month.
Remove the plastic grill if you can.
Some A/C units have a “fresh air vent” tab. This allows some mix of outside air inside the room. If
applicable, make sure it is closed.