Manualshelf

Instructions / Assembly

ManualsBrandsCoolaroo ManualsShadesTan Wheel-Operated PVC Exterior Shade 96 in. W x 72 in. L
12
INSTALL BRACKETS
A. Identify the Bracket-to-Bracket position of your
Shade (Fig. 1).
B. Use the the center of the screw holes to allow
for movement if necessary to provide a snug fit. The
Wheel bracket will be on the right side, and the Idle
end unit bracket should be on the le side; they
cannot be interchanged. (Fig. 2) for Wall Mount and
(Fig. 3) for Ceiling Mount.
INSTALLATION
INSTRUCTIONS
BLIND
EXTERIOR
by Coolaroo®
Congratulations on the purchase of your Exterior Blind by Coolaroo
®
. Please be sure to read the manual in its
entirety before installing your Shade.
ADDITIONAL TOOLS NEEDED
• Drill with 3/16 in. bit
• Level
PARTS LIST QTY
1 Wheel bracket 1
2 Wheel component 1
3 Headrail 1
4 Idle end plug 1
5 Idle end bracket 1
6 Shade 1
7 Bottom rail 1
(2) Wheel component
(1) Wheel bracket
(7) Bottom
rail
(6) Shade
(5) Idle
end bracket
(4) Idle end plug
(3) Headrail
20 minute set up
(approximate time)
Order replacement
parts online:
www.coolaroousa.com
Snap Idle
end plug into
Idle end unit
Fig. 5
© by GALE Pacific Limited. All rights reserved. Coolaroo
®
is a registered trademark of GALE Pacific Limited.
Questions or Comments? Contact us at:
GALE Pacific USA | www.coolaroousa.com | 1-800-560-4667
MAINTENANCE: Your Exterior Blind has been made of the finest materials and,
when properly cared for, will provide years of Shade and privacy. To clean your
Shade, simply rinse with water, scrub with mild soap or any nonabrasive cleaner,
rinse and allow to dry. Do not store Shade wet. In moist areas, roll Shade down
frequently to air dry. Call us for missing parts or mechanical problems.
CAUTION: Use of solvents or abrasive cleaners may damage the fabric and will
void your warranty. Do not use bleach or chlorine.
Retract your Exterior Blind when not in use, or before strong storms, to prevent damage.
Wheel
bracket
Idle end
bracket
Fig. 3 - CEILING MOUNT
Wheel Bracket
Fig. 4
IMPORTANT: With the Shade in place adjust the
brackets so they provide a snug fit. Now go back
and tighten the bracket screws completely. The
screws included in your hardware kit are for use
with wood only. See your retailer for mounting
recommendations when attaching your Shade to
any other material.
NOTE: Do not tighten screws completely yet.
ATTACHING THE SHADE
A. Insert the Wheel bracket into the Wheel
Component (Fig. 4). Then insert the Idle end plug
into the Idle end unit and snap the Idle end plug
securely into place (Fig. 5).
TAKE DOWN INSTRUCTIONS
A. To take your Shade down, make sure you have
one hand on the Shade and press inward on the Idle
end pin (Fig. 6).
B. Once you have pushed the Idle end pin inward,
the Shade will be released from the Idle end bracket.
• Tape measure
• Pencil
0.00.000.000
Fig. 1
Bracket-to-Bracket
1
2
Fig. 2 - WALL MOUNT
Idle end bracket Wheel bracket
Wheel Component
Fig. 6
Press inward
on the Idle
end pin

Summary of content (2 pages)