Installation Guide

5
INSTALL CRANK UNIT, IDLE END UNIT
A. Install Crank unit (through holes in valance
bracket)into pre-drilled holes.
B. Install Idle end unit (through holes in valance
bracket) into pre-drilled holes.
3
INSTALL SHADE
A. Insert the Clutch plug into the Crank unit
(Fig. 22).
B. Then insert the Idle end plug into the Idle end
unit, and snap the Idle end unit securely into place
(Fig. 23).
4
Fig. 18
Fig. 19
Inside Side Mount
Brackets facing away from window
Fig. 20
Fig. 21
Fig. 22
Fig. 23
SWITCH CLUTCH TO LEFT MOUNT
A. Remove both bracket covers, if installed (Fig.
18). You will not be using your bracket covers.
B. Your Shade comes standard with the clutch on
the right side of the Shade.
NOTE: Only do this step if you want to move
your clutch to the le side of the Shade.
C. Remove the four screws from the Crank unit.
D. Turn the Crank unit 180° so the wand eyelet can
now hang down from the le side (Fig. 19).
E. Put the screws back in.
1
SLIDE VALANCE INTO BRACKETS
A. Slide the valance into the two valance brackets
(Fig. 20).
B. Once the valance is in its brackets, slide entire
valance into place.
NOTE: Valance should stay in place on its own
(Fig. 21).
C. Mark your holes: With the valance and
brackets in correct position, mark holes where
screws will go. Take down valance and brackets and
pre-drill holes for screws, put valance and brackets
back into place.
2