Full Product Manual
Page 5
4.0 OPERATING PROCEDURES
4.2 STARTING THE PUMP
INITIAL STARTUP
On initial start-up the cooling media in your new unit will take a few hours
to become fully saturated. During this time an odor may emanate from
them. This odor will dissipate over time. For best results change the water
in the reservoir a few times.
SUBSEQUENT STARTUPS
On subsequent start-ups turn on the pump, start the fan and cool down.
LOW WATER INDICATOR
The FLURRY is equipped with a low water indicator light.
◊ When the power is on and there is sufficient water
in the reservoir, the light will be lit green, and the
pump will be running.
◊ When the power is on and the water in the reservoir
is getting low, the light will be lit red, and the pump
will stop running.
4.3 STARTING THE FAN
Turn the fan control knob clockwise to turn on the fan and adjust the
speed to your preferred setting.