Use and Care Manual

4.2 Starting the fan:

Turn the fan switch to HIGH speed on start-up, allow motor to reach maximum speed,

then set at Medium or Low.

IMPORTANT

DO NOT flood the pads with water, keep them moist. New pads take a few days to

become completely saturated. It is normal to have several dry streaks on the face of the

pads about 1 or 2 inches wide. If the streaks are larger or unevenly spaced, adjust the

flow control knob to allow more water to flow to the pads. NOTE: New pads may also

emanate an odor under initial operating conditions from the resin used to construct the

media. Flush the pads by running the pump without the fan running for approximately 2

hours. Empty the sump and refill. Repeat if odor still exists.

4.3 Starting the pump and adjusting the water flow:

NOTE: Have fan running while adjusting the water flow.

Once the sump is full, the pump switch may be turned to the ‘ON’ position. The flow

control knob will need to be adjusted on initial start-up. It is located at the right side of

the unit, it controls the volume of water that is delivered to the top of the cooling pads.

CAUTION

Prolonged use of hard water without proper water treatment will create mineral deposit

build up causing the pump to fail which is “NOT COVERED BY WARRANTY”

5.0 Maintenance and storage:

DANGER

ELECTRICAL SHOCK HAZARD

Disconnect the power supply before performing any service or

maintenance on the unit. Failure to do so may result in serious injury or

death.

The COOL-SPACE® unit is constructed of durable industrial grade components and

requires minimal maintenance. The housing is constructed of corrosion-free

polyethylene. The fan is galvanized for corrosion resistance. The motor is TEAO

moisture resistant specifically designed for wet applications. All other components are

designed for wet duty applications to ensure long life of the unit.

5.1 Removing the cooling media to access the inside of the unit:

In order to perform any maintenance on internal components, the cooling pads must be

removed to access the inside of the unit.