Cool-Living 10,000 BTU Thermostat Controlled Air Conditioner with Dehumidifier for 450 sq. ft. : Use and Care Manual : Page 6

6 / 18

1. Installation

Warning:

 Keep this mobile air-conditioner in an upright position for at least 4 hours before first installation.

 Keep the unit in upright position at all times, even when moving to a new location. The air-conditioner should

be placed on a flat surface.

 Do not install or operate this air-conditioner in a bathroom or other wet environments.

1.1 Installation of exhaust hose assembly and its adapter

1) Take out the exhaust hose assembly and its adapter from plastic bag.

2) Extend the exhaust hose at one end, screw the round end of adapter into exhaust hose in counter clockwise

direction (as Photo)).

Note: Screw adapter into position, at least 3 full rotations, to insure a good connection of exhaust hose assembly and

its adapter (as Photo).

1.2 Installation of the exhaust hose assembly into unit

1) Determine window seal-plate position, vertical or horizontal direction.

2) If window seal-plate will be in horizontal position, the slanted portion of the adapter should face right.

3) If window seal-plate will be in vertical position, the slanted portion of the adapter should be facing up.

1. Take the two ends of exhaust hose and its adapter assembly (in Photo below, figure A).

2. Put the hose end of the exhaust assembly without the adapter into exhaust vent on back panel (as in Photo).

Figure A.

Remarks: