Use and Care Manual

17 / 18
1. Screw off the drain cover, and then pull out the stopper to drain water completely.
Note: the tilt angle of the unit must be≦30
.
2. Keep the unit running in fan mode for 12 hours, to dry inside of unit completely, to prevent unit from going moldy.
3. Turn off the unit, pull out plug then wrap the power cord around the wire-winding pillar, insert the plug into the
universal fixing hole at the back panel of the unit, install the water plug and drain cap.
4. Remove the exhaust hose assembly and clean it.
5. Pack the air-conditioner properly with soft plastic bag and put it in dry place with appropriate dust-proof measures
and keep the unit away from children.
6. Take out the batteries from the remote control and keep it properly.
Note: Assure the unit is stored in a dry place. All accessories of the unit shall be properly protected together.
Troubleshooting
Please check the unit and suggestions below before asking for professional service, but never dismantle or repair the
unit by yourself, it may cause harm to you and your property.
Trouble
Cause
Remedy
The unit fails to start up
Power supply failure
Connect the unit to a live socket and
turn it on.
Water-full and its indicator lighting up
Drain the water stored in the unit.
Ambient temperature too low or too
high
It is recommended to use this unit
between 10-35℃（50-95℉.）
The room temperature is lower than
the set temperature in cooling mode.
Change the set temperature
Bad cooling effects
There is direct sunlight
Close the curtain
The doors and windows are open, the
room is crowded or there are other
heat sources
Close the door and window, remove
other heat sources, and add new
air-conditioners
Dirty filter
Clean or replace the filter.
Air inlet or air outlet clogged
Remove the obstruction
High noise level
The unit is being placed at uneven
surface.
Put the unit at a flat and firm place (may
reduce noise)
The compressor does
not work
Initiation of overheat protection.
Wait until the temperature decrease, the
unit will re-start automatically
The remote control does
not work
Too long distance
Bring the remote control close to the
air-conditioner and ensure airs at signal
receptor on unit.
The remote control didn’t aim at signal
receptor on unit.
The batteries have no electricity
Replace the batteries
LED displays error code
“E1”
Tube temperature sensor failure
Check the tube temperature sensor and
related circuits
LED displays error code
“E2”
Room temperature sensor failure
Check the room temperature sensor and
related circuits
LED displays error code
Anti-freeze protection
Restore the functions automatically