Use and Care Manual

15 / 18
When the water volume reaches its alarm level in the water tank, a warning will sound and the unit will
automatically stop working. The water-full indicator “FL” will be flashing on LED display window.
A. Put a drainage tray or catch pan below the water outlet at the back of the unit. (Tray is not included)
B. Screw off the drain cover, and unplug the water stopper to allow water to flow out of unit into tray.
C. After unit is completely drained, plug in water stopper and screw the water cover tightly onto water outlet.
Notes:
 Be careful not to damage the drain cover or water stopper.
 Tilt the unit slightly backwards when draining.
 If the tray is full before all the water has drained out, block the drain hole and empty tray. Continue to empty water
until excess water is drained. (Tray is not included)
 Water stopper and drain cover must be tightly installed, to avoid any water leakage.
2. Continuous drain feature:
NOTE: This unit does not come with drainage hose, must be purchased separately.
1) Screw off the drain cover and unplug the water stopper (as Photo).
2) Connect drain-hole with 13mm PVC drain hose, screw on tightly to avoid leakage (as Photo).
3) Make sure and draind the hose to bathroom or outdoors.
Notes:
 If using the continuous drain feature, the drainage hose must be installed before unit starts working.
 It is suggested to use manual drainage when unit in cooling mode, to ensure enough water to recycle in the unit
to cool condenser and enhance cooling performance.
 Put the drain hose in an inaccessible place, not higher than drainage hole and keep drain hose straight without
any flexure.
 Keep the drain cover and its stopper properly installed when continuous drainage is adopted.
Maintenance and Service
Remark: Turn off the unit and pull out the plug before maintain or send the unit to service center.
Drain Cover
Water Stopper
Drainage Hole
Drain hose
Drain cap
Water Stopper
Drain Hole