Use and Care Manual

12 / 18
 While the unit is running, Press “Timer” button to set automatic OFF feature, will light up.
 Enter the number of hours you would like the unit to run for. The unit will turn off automatically when the set
time has elapsed.
 Press “Timer” button to set automatic ON time while unit is off, will light up.
 Enter the number of hours you would like the unit to turn on in. The unit will turn on automatically and run
until it is shut down.
 When press “Timer” button is pressed, & will light up, on LED display. LED window will flash
in half second frequency, press or buttons within 5 seconds to finish timer setting, set time will flash
for 5 seconds for confirmation and will turn off, then room temperature will be shown on LED display
window.
 Under “Timer” function, press “Timer” once to check time remaining. Timer indicator will light up; press
“Timer” twice within 5 seconds to cancel timer, will turn off.
 The time can be adjusted within a range of 1-24 hours, press or buttons to increase or decrease
time in 1 hour increments.
 Unit will not change working modes after timer setting. Timer will not stop by other functions.
 Timer will be ineffective if any operation from control panel or remote control to turn on or turn off the unit.
3. Remote Control Operation
The Remote control transmits the signal to system.
Button: press this button to start or stop the unit when it is in
operation.
Button: press this button to set units automatic on and off time
Button: press this button to select high speed of fan. (except dry
and sleep modes)
Button: press this button to select low speed of fan.
Button: press this button to increase temperature or timer
setting.
Button: press this button to decrease temperature or timer
setting.
Button: press this button to make Celsius degrees and
Fahrenheit degrees interchange.
Button: press this button to select “Cool” mode.
Button: press this button to select “Fan” mode
Button: press this button to select “Dry” or “dehumidifying” mode